In recent years, the rapid development of market technical information, non-standard equipment may not be familiar to everyone, in fact, it is more popular in people's lives, many people are not familiar with its maintenance methods, then everyone Do you know the maintenance methods of non-standard equipment? What are the factors causing the failure? Let's take a closer look at the "maintenance steps and failure causes of non-standard equipment".

[Introduce the daily maintenance method of non-standard equipment]

Non-standard equipment is designed and customized according to its own needs. Due to the diversification of customer needs, non-standard equipment is becoming more and more popular. In daily production, the maintenance of non-standard equipment is very important. Good maintenance methods can greatly improve the work efficiency and service life of products.

1. The maintenance of non-standard equipment must first specify the appropriate maintenance standards according to the requirements in the instruction manual, and continuously improve the maintenance technical capabilities.

2. After a period of time, carefully check whether the pressure transmitter and adjustment valve in the equipment are tight, whether there is a problem of looseness and fall. If you find a problem during the inspection, you need to take it immediately Measures can be taken to solve these problems, and you cannot ignore these details because you think the problem is not big.

3. Always check whether the temperature sensor in the equipment has been dampened for various reasons, or if water has entered the equipment.

4. When using it, pay attention to check whether the data of the electromagnetic flowmeter of the device is accurate. If any problem is found, it should be adjusted immediately.

[Talk about the two main failures of non-standard equipment]

Most of the reasons for the failure of the power supply of non-standard equipment are caused by the open circuit of the power cord or the ground wire, the wrong connection or poor contact, but sometimes the voltage of the equipment or circuit board exceeds The allowed range may also be caused by the failure of its own power pack. If you have experience in this situation, you can directly solve it.

The main reason for the failure of passive components of non-standard equipment is the open circuit caused by the broken circuit of the capacitor and the loose end cap of the resistor, which causes the resistance value to change.

 When the resistance value changes, it will cause a series of problems, which may be accompanied by poor decoupling, oscillator frequency changes, and motors and other equipment unable to start. Therefore, when encountering such problems, you can determine the real cause of the money according to the problems that may accompany it, and then you can make a decision.